3M – Dust/Safety Mask – FFP2 – Pack of 20

3M 8810 Cup Shaped FFP2 Respirator

Main Features:
The 3M 8810 respirator provides lightweight, effective,comfortable and hygienic respiratory protection against dusts and mists. The convex shape, twin strap design, foam nose seal and aluminium nose clip ensure a good face seal over a wide range of face sizes.

The 3M 8810 is exempt from costly time consuming maintenance requirements. The 3M 8810 is quite literally “maintenance-free”.

Applications:
– Base Metal Manufacture: Pharmaceuticals
– Laboratories: Foodstuffs e.g. Bagging
– Powdered Additives: Powdered Chemicals
– Sawmills

Approvals:
– The 3M 8810 has been shown to meet the Basic Safety Requirements under Article 10 and 11B of the European Community Directive 89/686.
– Meets the performance requirements of the European Standard for filtering facepiece dust respirators EN149:2001 FFP2.
– Is suitable for use under COSHH, CAW, CLAW and IRR.
– The product is CE-marked.
– The Product is Homologated.

Materials:
The following materials are used in the production of this product:
– Straps: Natural Rubber.
– Nose-clip: Aluminium.
– Filter/shell: Polypropylene/Polyester.
– Nose foam: Polyurethane.
– Weight: 8g.

Standards:
The product has been tested to the NEW European Norm EN149:2001and has met the requirements of category FFP2 in this standard.
The main performance tests in this standard are:
– Filter Penetration
– Total Inward Leakage
– Flammability
– Breathing Resistance
– Performance

The 8810 is at least 92% efficient against fine dusts, water based and non-volatile liquid aerosols down to 0.5 micron. It offers an Assigned Protection Factor of 10 (Nominal Protection Factor of 12); i.e., it can be used in atmospheres containing up to 10 times the Occupational Exposure Limit (OEL) of contaminant as specified in the Health & Safety Executive Guidance note EH40. As detailed in BS4275: 1997

Warnings:
– As with the use of any respiratory device, the wearer must first be trained in the proper use of the product.
– This product does not protect the wearer against gases, vapours, solvents from paint spray operations or atmospheres containing less than 19.5% oxygen.
– Use only in adequately ventilated areas containing sufficient oxygen to support life.
– Do not use when concentrations of contaminants are immediately dangerous to life or health.
– Leave the area immediately if: breathing becomes difficult, dizziness or other distress occurs
– Discard and replace respirator if it becomes damaged, breathing resistance becomes excessive, or at the end of one shift.
– Never alter or modify this device.

Typical Applications:
Base Metal Manufacture, Pharmaceuticals, Laboratories, Foodstuffs e.g. Bagging, Pow-dered Additives, Powdered Chemicals, Sawmills
For additional information and limitations of use please refer to 3M8810 data sheet. Specifications may change without prior notification.

What’s in the box
1 x Box of 3M Dust Masks (20 Masks per Box) – FFP2